Sneaky Snatcher Table Lamp – proiect STL 3D

Descriere

3D MODEL DESCRIPTION

Looks like someone’s stealing Christmas… Well anyway, that would look great with green light.
This STL file is recommended for FDM Printers!
3D Printing Time Based on Ender 3: 01 Day, 02 Hours, 40 Minutes (will vary accord to you printer model)
Approximately Height: 11,5 cm
You Will Need To: RGB LED Board 5V – AliExpress

3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE)

Line Width/ Nozzle: 0.4 mm
First Layer Line Width: 0.48 mm / 120%
Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) | 20 mm/s (First Layer) / 500 mm/s (All the other layers on Bambu Lab)
Recommended Initial Layer Height: 0.20 mm
Recommended Layer Height: 0.20 mm
Recommended Perimeters/ Walls: 3.
Recommended Infill (%): 10% (Gyroid)
Needs Support: No.
Build Plate Adhesion: None. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing! Assembly Instructions Stick the LED using double-sided tape. Insert the LED holder as shown in the image. Arrange the wire as shown in the image. The „Gift Pack” piece has two guides. Slide the support as shown in the image. Make sure it is properly fitted.

 
Vrei să cumperi produsul printat 3D?
 
Mergi la pagina de produs